View Profile: DNA Dan - F150 Ecoboost Forum
Tab Content
More Activity
About DNA Dan

Basic Information

About DNA Dan
Location:
Hamilton, MT
Interests:
Anything Outdoors

Signature


2012 SCREW Eco FX4 Tuxedo Black, Fully loaded, Max Tow, 3.73 rear.
ARE Z-Series topper w/Yakima rack, Bilstein 5100's, StopTech Sport brakes, BFG T/A KO2 on stock rims, RXP Catch can w/UPR check valves, FR Gen 2 Radiator, Saudi Trans cooler, CR Performance Engineering exhaust manifolds, Firestone Air bags.

Statistics


Total Posts
Total Posts
857
Posts Per Day
1.89
General Information
Last Activity
Today 08:15 PM
Join Date
04-24-2018
Referrals
0

04-30-2019


02-23-2019


09-07-2018


05-29-2018


Page 1 of 32 12311 ... LastLast

07-18-2019


07-12-2019


07-11-2019


07-10-2019


07-09-2019


07-07-2019



Page 1 of 32 12311 ... LastLast

28 Likes

Page 1 of 2 12 LastLast
  1. DNA Dan
    DNA Dan liked post by SuperDave23 On thread : The Beast finally reveals itself
    Based on what I've seen with my stock gauge you were just barely cracking 230F. My needle goes straight vertical around 232F and at 240F it's at about 3/4 of the guage. I think red is right around...
    Liked On: 07-07-2019, 11:13 AM
  2. DNA Dan
    DNA Dan liked post by Blown F-150 On thread : Injector seal intaller
    I would swap manifolds any day over doing injectors! There is next to no room to work in the valley. For specialty tools, you really just need the seal sizer. I couldn't source one through OTC, so...
    Liked On: 07-02-2019, 06:25 PM
  3. DNA Dan
    DNA Dan liked post by RMB_Ryan On thread : Injector seal intaller
    Just go ahead and cut these tabs right off and donít waste your time. They do nothing a zip tie canít do better and they are in the way. Especially when in the truck. I bench install them because...
    Liked On: 07-02-2019, 05:25 PM
  4. DNA Dan
    DNA Dan liked post by RMB_Ryan On thread : Injector seal intaller
    Itís a real SOB!!! I hate it personally. I have done it so many times I canít count. This is all you need https://uploads.tapatalk-cdn.com/20190702/97b4b981a2f1d0dc2afcafd32b993dd1.jpg
    Liked On: 07-02-2019, 05:25 PM
  5. DNA Dan
    DNA Dan liked post by BAD454SS On thread : First tow of the 2019 Season
    It is a complete separate wired Relay ,fuse wire and switch . Unplug factory wired plugs to fans . Plug in new connectors wired to its own relay /fuse /switch system .Mike has my old set up i ran...
    Liked On: 05-21-2019, 08:28 AM
  6. DNA Dan
    DNA Dan liked post by BAD454SS On thread : First tow of the 2019 Season
    This set-up gives Mike maximum cooling from get go during his towing excursion instead of computer screwing with fans turning on hi or low or off. If his coolant gets hot now this summer he is...
    Liked On: 05-21-2019, 08:28 AM
  7. DNA Dan
    DNA Dan liked post by zukgod1 On thread : Strange noise while driving
    It's a 7A788. It's an assembly of course.https://uploads.tapatalk-cdn.com/20190515/2b80ff51562c07e29abc138ef666a0f4.jpg Sent from my Pixel 2 XL using Tapatalk
    Liked On: 05-15-2019, 08:45 AM
  8. DNA Dan
    DNA Dan liked post by 2016BoostedGreyGoose On thread : Jiffy tite connector torque specifications Help!
    I did this on my 2016. I didnt remove the AC compressor or both belts...I only removed the belt that goes around the idler and the alternator. Was tougher NOT removing the AC, but overall I am glad I...
    Liked On: 04-23-2019, 08:57 AM
  9. DNA Dan
    DNA Dan liked post by R0bCincy On thread : Ford recall for transmission issue
    Good info on the 2011 and 2012 recall. https://ford.oemdtc.com/2679/16n02-molded-leadframe-extended-coverage-2011-2012-ford-lincoln Includes parts list and replacement process overview.
    Liked On: 03-11-2019, 08:48 AM
  10. DNA Dan
    DNA Dan liked post by Eco_Boone On thread : Coolant leak near turbo?
    6L625-A and 6L625-B are accessible with engine in truck. Removing CAC tubing is a must to get at them and even then I have my wheel well liners removed. If you remove wheel well liner its 10x easier...
    Liked On: 03-07-2019, 11:23 AM
  11. DNA Dan
    DNA Dan liked post by Muddy45 On thread : 2014 3.5 white smoke on startup
    So I found the culprit of the smell. It was the 7 way interface harness for my topper. It just happened to burn up at the same time i started the truck and backed it out and the way the breeze was...
    Liked On: 03-06-2019, 07:13 AM
  12. DNA Dan
    DNA Dan liked post by admin On thread : Site Running Slow
    Hello there, The techs have pinpointed the issue to the slowness. Once the patch is done, they will deploy the fix. I do not have an ETA on this, but once I get an update, we'll give you a heads...
    Liked On: 03-05-2019, 10:16 AM
  13. DNA Dan
    DNA Dan liked post by R0bCincy On thread : New Intercooler fix?
    Trying to retro fit a later model intercooler to your current truck would be a bigger hassle than it is worth. By the time you buy it and try to get it setup you would have been better off buying a...
    Liked On: 03-05-2019, 09:48 AM
  14. DNA Dan
    DNA Dan liked post by Purefection On thread : Site Running Slow
    Can you guys post results from www.fast.com when you're having issues? Will help us to determine if the issue is local to a certain area or not. I'm not having any issues today. Also post if using...
    Liked On: 03-04-2019, 02:04 PM
  15. DNA Dan
    DNA Dan liked post by Eco_Boone On thread : Coolant leak near turbo?
    Correct. Sent from my iPhone using Tapatalk
    Liked On: 02-26-2019, 09:20 AM
Page 1 of 2 12 LastLast
Connect with us: F150 Ecoboost Forum on Twitter F150 Ecoboost Forum on Facebook F150 Ecoboost Forum RSS Feed
Find us on Google+