F150 Ecoboost Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi all,

I bought the easygo pushbutton ignition kit and although the kit is specific for a 2013 F150, the installation instructions are generic as hell. Not the step by step guide I was hoping for. Most of the kit is a series of harness's that are all plugged into a central "ecu" and lead to all the sensors included in the kit, but the harness that actually interfaces with the truck has to be spliced into the truck.. Most of the wires terminate in places Ill have no issue finding (horn, brake light, door unlock, parking lamp) but two wires have me confused and questioning if I should even attempt to install this.

The instructions say to connect the two wires in question into the CAN/LOW and CAN/HI. Im familiar with the concept of a CAN system, but have no clue where to look for access to the HI/LOW wires.. Anyone know the answer to the riddle?
 
1 - 1 of 1 Posts
Top