F150 Ecoboost Forum banner

1 - 18 of 18 Posts

·
Registered
Joined
·
271 Posts
Discussion Starter #1
Finally doing something to my 2013 FX4. Arriving hopefully tomorrow will be a Randy Ellis Design Sleekster Lightbar & 4 Vision X LED Lights (4" - 2 - 60deg & 2 - 10deg). That should light up the backroads when coming out from bear camp. The only issue I am trying to work out is what type of light switch to use, & where to put them.

I'll post some photos when its done.
 

·
Registered
Joined
·
271 Posts
Discussion Starter #2
Got the lights & bar here finally. Got everything installed, just have to get them wired up.



 

·
Registered
Joined
·
271 Posts
Discussion Starter #5
Looks great! So nice you have a garage big enough to keep your truck in too.
Yes, just big enough with all the crap I have in it.. Though for these photos it was backed up a bit.
 

·
Registered
Joined
·
271 Posts
Discussion Starter #6 (Edited)
Here is a shot with the lights on from the outside.. I'll try to get some in cab shots this week.
 

·
Registered
Joined
·
271 Posts
Discussion Starter #8
ughhh you have all that snow already?? Jealous
Ya, around 6-8" in my area... some areas over a foot.... found that the e-locker is very nice through the drifts to keep me going...
 

·
Registered
Joined
·
271 Posts
Discussion Starter #9





First Photo: HID & Fog Lights
Second Photo: HID's on bright
Third Photo: 60deg Throw lights
Fourth Photo: 10deg Throw
Fifth Photo: both 60deg & 10deg lights

All aux lights shown are on with out headlights on.
 

·
Registered
Joined
·
1,529 Posts
Looks great!

SPPD
 

·
Registered
Joined
·
271 Posts
Discussion Starter #12
Thanks all...
 

·
Registered
Joined
·
271 Posts
Discussion Starter #13
Time for the next mod... Today my full skid plate package from RCI metalworks arrived.. now to find time to get them installed!
 
  • Like
Reactions: GeneralSantaAna

·
Registered
Joined
·
343 Posts
Just curious as to why you went with the Randy Ellis Lighter Bar instead of the Smittybilt that's about $100 less. Build quality?
 

·
Registered
Joined
·
271 Posts
Discussion Starter #16
Just curious as to why you went with the Randy Ellis Lighter Bar instead of the Smittybilt that's about $100 less. Build quality?
I think at the time I got mine the smittybuilt version was not out yet.... I know I looked at quite a few before going with the Randy Ellis one.
 

·
Registered
Joined
·
271 Posts
Discussion Starter #17

·
Registered
Joined
·
271 Posts
Discussion Starter #18
ImageUploadedByTapatalk1422153531.157568.jpg here's where I have my 2 switches.
 
1 - 18 of 18 Posts
Top